Router Table & Fence #1: Just added a PinnAcle fence and dust ports

Published May 4, 2010 at 2:41 a.m.

I have been wanting to get this project completed for some time and now its on its way to being done. I built this about a year ago and it had served well but it was difficult to set up without a fence until now. I picked up the PinnAcle fence on closeout at Wood Craft and got the dust port parts while I was there as well.
I had the T-Slots so I put them in and I will make some feather boards tomorrow and install the front T-Slot for that T-slot then one day this week I will go back to Wood Craft and get the material for the face of the fence!
So this is where it is so far any ideas for additional features are welcome.
You can see the “Y” dust port that pulls from the top and from the box.
]
As soon as I figure out the feather board size I can set the next T-Slot- Also notice the adjustable T-Slot at the top that will also hold the feather boards that hold stock down from kicking up.
]
Here is the box that has a vacuum port to remove dust from the box.
]
On this photo I will add a bit storage area and some doors.
]

Back | Read more at Lumberjocks blogs